CC2530 2.4GHz Zigbee SMD Wireless Module
Model E18-MS1-PCB manufactured by Ebyte
Confirmed working with
If the device is following Zigbee standards it is possible it will work with other gateway solutions, it is just not confirmed as working yet!
This module consists of a TI CC2530 with 2.5mW transmit power.
PCB pins are 1.27mm and slightly harder to solder wires to.
To be able to use it as a coordinator or router you need to flash the CC2530_ Z-Stack-firmware.
Identify the required pins and follow flashing instructions:
- flash using CCLoader and NodeMCU/Wemos D1 mini (or similar ESP8266 board)
- flash using Raspberry Pi
- flash using CC Debugger
VCC pin tolerates 3.6V max. DO NOT connect to 5V.