CC2530 PA+LNA 2.4GHz 100mW Zigbee SMD Module with IPX
Model E18-MS1PA2-IPX manufactured by Ebyte
Confirmed working with
If the device is following Zigbee standards it is possible it will work with other gateway solutions, it is just not confirmed as working yet!
This module consists of a TI CC2530 and a PA+LNA power amplifier chip. With 20dbm transmit power its realistic indoor range is 10-12m.
PCB pins are 1.27mm and slightly harder to solder wires to.
To be able to use it as a coordinator you need to flash the CC2530_CC2591_xx Z-Stack-firmware.
Flashing Instructions
Identify the required pins and follow flashing instructions:
- flash using CCLoader and NodeMCU/Wemos D1 mini (or similar ESP8266 board)
- flash using Raspberry Pi
- flash using CC Debugger
VCC pin tolerates 3.6V max. DO NOT connect to 5V.