Single Channel Receiver
Model SLR1b manufactured by Hive
Zigbee ID: SLR1b
Confirmed working with
If the device is following Zigbee standards it is possible it will work with other gateway solutions, it is just not confirmed as working yet!
Pairing instructions
- Remove the thermostat from the wall and remove a battery
- Turn boiler off at the mains, this will also turn off the receiver.
- Turn the boiler on
- Hold down central heating button on the Hive receiver until light turns pink, then release
- Hold down the central heating button again until the light turns amber with double flashing
- Pair with Home Assistant - using ZHA’s ‘add device’
- At this point the amber double flash may change to a single flash
- Stop ZHA from searching for devices by pressing back
- Replace the battery in the thermostat and allow to boot
- Press and hold the menu and back buttons, allow the countdown to finish and release when you see ‘welcome’ - after selecting - a language, it will enter pairing mode.
- On ZHA select the Hive receiver device you added earlier, now click “ADD DEVICES VIA THIS DEVICE”
- The thermostat should now pair to the boiler receiver. The amber light should turn green.