Leak & Temperature Sensor
Model 8850600 manufactured by LeakSmart
Zigbee ID: leakSMART Water Sensor V2
Confirmed working with
If the device is following Zigbee standards it is possible it will work with other gateway solutions, it is just not confirmed as working yet!
To reset the sensor, remove the battery door, install batteries, press and hold the black button for 15 seconds, then let go. Then power cycle the sensor by removing and reinstalling a battery. Upon reinstallation of the battery, the sensor should chirp and the Blue LED light will flash 5 times every second. This indicates it’s properly reset and ready to join the system. Note: You can remove the sensor