Supports:
coordinator

Available from:
Itead.cc
Aliexpress.com
Domadoo.fr

Manufacturer:
Sonoff.tech

Confirmed working with

Flashing

Flashing the device does not require soldering. When flashing, flash the Tasmota Release “Tasmota32 Sonoff-ZigbeeBridgePro” to have all the required files and filesystem changes pre-done.

Once flashed, follow the coordinator firmware flashing Instructions from NotEnoughTech to flash the CC2652 chip itself from within Tasmota: Flashing coordinator firmware by NotEnoughTech

Tasmota GitHub Discussion

For Home Assistant (ZHA or Zigbee2MQTT)

This mode creates a TCP bridge from the zigbee module to Home Assistant or Zigbee2MQTT. In this case Tasmota is only relaying all the messages from the zigbee module and you cannot use any Zigbee commands in Tasmota console in this mode. All setup needs to be done from the Home Assistant ZHA integration or Zigbee2MQTT addon.

Auto Configuration

After Zigbee firmware is flashed and confirmed working in Zigbee2Tasmota mode, open the web UI of the device and navigate to Configuration -> Auto-configuration. Select Sonoff ZBPro TCP from the drop-down and click Apply Configuration.
The device will restart and will be automagically configured.

Manual Configuration

After Zigbee firmware is flashed and confirmed working in Zigbee2Tasmota mode, apply the template:

{"NAME":"TCP ZBBridge Pro","GPIO":[0,0,576,0,480,0,0,0,0,1,1,5792,0,0,0,5472,0,320,5793,5504,0,640,608,32,0,0,0,0,0,1,0,0,0,0,0,0],"FLAG":0,"BASE":1}

Run the following command to:

• Create a rule in tasmota to start TCPBridge on port 8888 on boot
• Enable the above rule
• Start TCP on port 8888

  backlog rule1 on system#boot do TCPStart 8888 endon ; rule1 1 ; TCPStart 8888
  

  You can change 8888 to a port you prefer.

Connecting to Home Assistant with ZHA

In Home Assistant (requires version 0.113+) go to Configuration - Integrations, click the + icon, search for ZHA integration and select it.

1. for Radio Type choose “ZNP”
2. choose “software” for ‘data flow control’
3. under “Serial device path” enter socket://[zbbridgePro_ip]:8888 replacing [zbbridgePro_ip] with its IP address. Do not use hostnames.
   • if you changed the port number use yours
   • ensure port speed is set to “115200”
4. when the ZbBridgePro is discovered you will get a confirmation message

Connecting to Home Assistant OS with Zigbee2MQTT

This assumes you already have a basic knowledge of installing custom addons in HAOS, MQTT and have an MQTT broker already configured within Home Assistant OS.

1. Install Zigbee2MQTT Add On by adding the custom github repository.
2. Add the following line to the Configuration > Options > Serial text field.
   • replace [zbbridgePro_ip] with its IP address
   • if you changed the port number use the configured port

     port: tcp://[zbbridgePro_ip]:8888
     

Connecting to a separate Zigbee2MQTT installation may require further setup. Zigbee2MQTT Remote Adapter Guide

Router Firmware

GitHub Discussion