Confirmed working with

Pairing Instructions

Press and hold the button on the device until the blue light starts blinking, release it and the pairing should begin.

If you're having problems pairing, try keeping the device alive (press the button every second) after pairing started, until pairing completed (source: ZHA with Zigate and Aqara device).

If you're having connection or pairing issues read Xiaomi & Aqara Devices - Pairing & Keeping them connected.

Binding

By default the switch is bound to the coordinator but this device can also be used to directly control other lights and switches in the network.

First you probably want to unbind it from the coordinator first, then you can bind it to any other device or group. see

As the device is sleeping by default, you need to wake it up after sending the bind/unbind command by pressing the reset button once.

When bound to a lamp, the behavior is as follows:

• left click: turn off
• right click: turn on
• left double click: light dim down (by steps of 33%)
• right double click: light dim up (by steps of 33%)
• long left click: warm white
• long right click: cold white

Zigate on Domoticz

Here are the events you will receive on the Domoticz widget, 5 events per buttons

• left click
• right click
• left double click
• right double click
• right triple click
• left triple click
• left long click
• right long click
• left release
• right long click

Zigbee2Tasmota

This device has 2 operation modes. Changing mode of the switch requires the following commands:

Read mode:

ZbSend {"Device":"<device>","Manuf":"0x115F","Read":{"OppleMode":true}}

Write mode (0 or 1):

ZbSend {"Device":"<device>","Manuf":"0x115F","Write":{"OppleMode":1}}
ZbSend {"Device":"<device>","Manuf":"0x115F","Write":{"OppleMode":0}}